Filter
Top Products
8
6. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (53) so the treadmill is more stable; do
not fully fold the Frame yet.
Attach a Base Pad (79) to the Base (80) in the
location shown with a Base Pad Spacer (25)
and a 1" Tek Screw (56). Then, attach another
Base Pad (79) with only a 1" Tek Screw (56).
Attach a Base Wheel (81) with the 3/8" x 2" Bolt
(4) and the 3/8" Nut (8) that you just removed in
step 1. Do not overtighten the Nut; the Base
Wheel must turn freely.
6
80
81
53
4
8
79
56
79
25
56
7. With the help of a second person, hold a Bolt
Spacer (3) inside the lower end of the Left
Upright (71). Insert a 3/8" x 4" Bolt (6) with a
3/8" Star Washer (9) into the Left Upright and
the Bolt Spacer. Repeat this step with a second
Bolt Spacer (3), 3/8" x 4" Bolt (6), and 3/8" Star
Washer (9).
Orient the Left Upright (71) and the Left Upright
Spacer (73) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(80). Finger tighten the 3/8" x 4" Bolts (6); do
not fully tighten the Bolts yet.
Press a Base Endcap (75) into the Base (80).
With the help of a second person, tip the tread-
mill so that the Base (80) is flat on the floor.
73
71
6
80
3
3
75
9
7
5. Hold a Bolt Spacer (3) inside the lower end of
the Right Upright (72). Insert a 3/8" x 4" Bolt (6)
with a 3/8" Star Washer (9) into the Right
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (3), 3/8" x 4" Bolt (6),
and 3/8" Star Washer (9).
Hold the Right Upright Spacer (74) and the
R
ight Upright (72) against the Base (80). Be
careful not to pinch the Upright Wire (78).
Finger tighten the 3/8" x 4" Bolt (6); do not fully
tighten the Bolts yet.
Press a Base Endcap (75) into the Base (80).
74
72
78
9
75
3
3
6
5
80