Filter
Top Products
7
3. Find the Left Pedal (31), which has a ridge on the
right side. Attach the Left Pedal to one of the Pedal
Arms (12) with three M4 x 19mm Round Head Screws
(16) as shown.
Repeat this step to attach the Right Pedal to the other
Pedal Arm (not shown).
3
31
Ridge
Front
12
16
4. Identify the Left Handlebar (8) (there is an “L” sticker
on the Left Handlebar for identification).
Make sure that there are two Pedal Arm Bushings
(42) in each Pedal Arm (12).
Slide a Handlebar Spacer (39) and the Pedal Arm (12)
with the Left Pedal (31) onto the Left Handlebar (8) as
shown. (Note: These parts fit tightly; it may be helpful
to use the rubber mallet). Next, refer to the PART
IDENTIFICATION CHART on page 5 and identify the
3/4” Axle Caps (43). Tap a 3/4” Axle Cap onto the Left
Handlebar.
Repeat this step to attach the other Pedal Arm (12) to
the Right Handlebar (64).
5. Slide a Weld Spacer (49) onto the left axle on the
Upright (3). Make sure that the open side of the Weld
Spacer is facing the Upright.
Slide a Pedal Arm Spacer (41) onto the left Crank Arm
(59).
Make sure that there are two Rear Pedal Arm
Bushings (11) in the Pedal Arm (12) attached to the
Left Handlebar (8).
With the help of another person, slide the Left
Handlebar (8) onto the left axle on the Upright (3)
while sliding the left Pedal Arm (12) onto the left
Crank Arm (59). Note: These parts fit tightly; it may be
helpful to use the rubber mallet. In addition, it may be
helpful to rotate the left Crank Arm (59) to a different
position.
Tap a 5/8” Axle Cap (57) onto the left axle on the
Upright (3).
Tap a 3/4” Axle Cap (43) onto the left Crank Arm (59).
Repeat this step to attach the Right Handlebar and
the right Pedal Arm (not shown).
59
41
11
12
49
57
3
43
8
8
64
42
43
12
12
4
39
31
5