Filter
Top Products
6
ASSEMBLY
Assembly requires two people. Place all parts of the PROFORM
®
485E in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench , a phillips screwdriver , two adjustable
wrenches , and a rubber mallet .
1. While another person holds the Upright (3) near the
Frame (1) as shown, gently pull the Resistance
Cable (26) and the Sensor Wire (25) out of the top
of the Upright until there is no slack between the
Upright and the Frame.
Slide the Upright (3) onto the welded bolts on the
Frame (1). Be careful to avoid pinching the
Resistance Cable (26) and the Sensor Wire (25).
Tighten an M10 Nylon Locknut (29) onto each weld-
ed bolt.
2. While another person holds the Console (6) near
the Upright (3), connect the console wire to the
Sensor Wire (25).
Feed the slack Sensor Wire (25) back down into the
Upright (3). Attach the Console (6) to the Upright
with four Console Screws (2). Be careful to avoid
pinching the Sensor Wire (25).
Press the Resistance Knob (50) onto the
Resistance Control (26).
1
Console
Wire
3
1
25
26
29
Welded
Bolts
3
50
26
25
6
2
2