Filter
Top Products
7
2. Have a second person hold the Base (52) in the
position shown.
Identify the Left Upright (53) (the Right Upright
[
54] has a large hole near the lower end).
Hold the Left Upright (53) so the two small
holes for the latch assembly are on top as
shown. Insert two M10 x 58mm Bolts (2) into
the bracket on the Left Upright. Attach the Left
Upright to the Base (52) with the Bolts, two M10
Star Washers (9) and two M10 Jam Nuts (16).
Do not tighten the Nuts yet.
Attach the Right Upright (54) to the Base (52)
in the same way.
2
52
53
16
2
2
16
9
9
9
9
54
Large
Hole
Small Holes
3. Slide the two Wheel Housings (45) onto the Base
(52). Attach each Wheel Housing with two M6 x
58mm Bolts (13), two M6 Washers (32), and two
M6 Nuts (43).
3
52
13
32
32
45
43
13
32
32
45
43
4. Position the Base (52) as close to the front of
the treadmill as possible, as shown.
See the upper inset drawing. Wrap the wire tie
in the Right Upright (54) around the end of the
Wire Harness (39). Then, pull the other end of
the wire tie until the Wire Harness is extending
from the upper end of the Right Upright. Secure
the Wire Harness to the top of the Right Upright
so that it will not fall inside.
See the lower inset drawing. Press the indicated
Grommet (49) into the Right Upright (54).
52
4
39
54
54
54
49
39
52
Wire Tie
4b
4a
39