Filter
Top Products
5
2. While another person lifts the back of the Frame (1)
slightly, attach the Rear Stabilizer (30) to the Frame
with two M10 x 75mm Carriage Bolts (33) and two
M10 Black Nylon Locknuts (34).
33
30
1
3
15
46
34
6
13
3. Attach the Handlebar (15) to the Upright (13) with two
M10 x 42mm Button Bolts (6), two M10 Split Washers
(46), and two M10 Black Nylon Locknuts (34).
2
4
34
34
5. Hold the Console (16) near the Upright (13). Connect
the Extension Wire (49) to the Console wire.
Insert the excess wire into the Upright (13). Attach the
Console (16) to the Upright with four M4 x 16mm
Screws (32). Make sure that the wires are not
pinched.
4. The Console (16) requires four “D” batteries (not
included); alkaline batteries are recommended.
Remove the indicated screw from the battery drawer,
and pull the battery drawer open. Insert four batteries
into the battery drawer; make sure that the batteries
are oriented as shown by the markings inside of
the battery drawer. Close the battery drawer and
reattach the screw.
16
Batteries
Screw
32
Console
W
ire
13
49
16
5
32
46