Filter
Top Products
7
2. With the help of a second person, carefully lower the
treadmill frame and then tip the Uprights (69) down as
shown. (Note: It may be helpful to place your foot on one
of the Extension Legs [63] as you tip the Uprights.) Make
sure that the Extension Legs remain in the Uprights.
Attach each Extension Leg (63) with two 3/4” Tek
Screws (58).
Attach four Base Pads (57) with 3/4” Tek Screws (58) as
shown.
Note: One replacement Base Pad (57) may be included.
If a Base Pad becomes worn and needs to be replaced,
use the replacement Base Pad.
58
58
58
58
58
58
63
69
57
57
63
57
57
2
4. Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Wire Harness (42) up into the
bracket on the Right Handrail and out of the large hole in
the left side. (Note: It may be helpful to use needlenose
pliers to pull the Wire Harness out of the large hole.)
Press a Handrail Cap (76) onto the lower end of the
Right Handrail as shown.
Insert the bracket on the Right Handrail (72) into the top
of the right Upright (69) so the Handrail Cap (76) is rest-
ing against the Upright. Attach the Right Handrail and the
Handrail Cap with three 1” Bolts (37) and two Washers
(38) as shown. Firmly tighten the indicated Bolt, but
do not tighten the other Bolts yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
Bracket
Tighten
76
72
69
42
4
38
38
37
37
37
Large
Hole
3. With the help of a second person, raise the Uprights (69)
to the vertical Position. Attach the Storage Latch (36) to
the left Upright with two 3/4” Screws (2). Remove the
Latch Knob (30) from the Latch Pin (35). Make sure that
the Latch Pin Collar (33) and the Spring (32) are on the
Latch Pin as shown. Insert the Latch Pin into the Storage
Latch, and tighten the Latch Knob back onto the Latch
Pin.
35
33
32
36
30
Large
Hole
69
2
3