Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
wire cutters , and needlenose pliers .
Note: If a part is not in the parts bag, first check to see if it has been pre-assembled. If a part is missing,
call toll-free 1-800-999-3756.
To identify small parts, use the PART IDENTIFICATION CHART below.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully raise the
Uprights (69) until the treadmill is in the position shown.
Insert one of the Extension Legs (63) into the treadmill as
shown. (Note: It may be helpful to tip the Uprights as you
insert the Extension Leg.) Make sure that the Warning
Decal (62) is on the indicated side of the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
69
63
62
1
6
3/4” Screw (2)–8
1/2” Silver Screw (48)–1
Washer (38)–4
Silver Ground
Screw (75)–1
Wheel Bolt (64)–2
1” Bolt (37)–6
Wheel Nut (104)–2
3/4” Tek Screw (58)–8