Filter
Top Products
5
3. See figure 3b. Find the Right Leg (7). Note: The
Right Leg is marked with a ÒRIGHTÓ sticker.
Set a Pedal (28) on the plate at the lower end of
the Right Leg. Note: Be careful not to attach
the Pedal backwards. Look at the curve of the
Right Leg and the front end of the Pedal to
make sure that the Pedal is turned correctly.
See figure 3a. Turn the Right Leg (7) and the
Pedal (28) upside-down as shown. Attach the
Pedal with four #8 x 1/2Ó Screws (31).
4. See figure 4. Look into the upper end of the
Right Leg (7) and make sure that the Plastic
Sleeve (41) is fully inserted.
See figure 4. Find the Right Handle (11). Note:
The Right Handle is marked with a ÒRIGHTÓ
sticker. Insert the Right Handle into the Right
Leg (7).
See figure 4. Slide a 3/8Ó Curved Washer (27)
onto a 2Ó Upper Screw (25). Note: Use the
actual-size drawing to identify the 2Ó Upper
Screw (25). Insert the 2Ó Upper Screw into the
upper hole in the Right Leg (7) and the Right
Handle (11).
See figure 4. Slide a 3/8Ó Curved Washer (27)
onto a 2 1/4Ó Lower Screw (26). Note: Use the
actual-size drawing to identify the 2 1/4Ó
Lower Screw (26). Insert the 2 1/4Ó Lower
Screw into the lower hole in the Right Leg (7)
and the Right Handle (11).
See figure 4. Make sure that the 2Ó Upper
Screw (25) is in the upper hole, and that the
2 1/4Ó Lower Screw (26) is in the lower hole.
The Screws must be inserted from the side
shown.
Fig. 4
27
11
41
7
26
25
7
31
28
2 1/4Ó Lower Screw (26)
Note: This step requires one 2Ó Upper Screw (25)
and one 2 1/4Ó Lower Screw (26). The 2Ó Upper
Screw (25) must be in the upper hole; the 2 1/4Ó
Lower Screw (26) must be in the lower hole.
Fig. 3a
ÒRIGHTÓ
Sticker
ÒRIGHTÓ
Sticker
2Ó Upper Screw (25)
Fig. 3b
Front
End
28
Right Leg
Curves in This
Direction
ÒRIGHTÓ
Sticker
7