Filter
Top Products
4
ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it has been pre-attached.
M10 x 75mm Carriage Bolt (72)–2
M8 Washer (55)–7
M6 Washer (54)–3
M8 x 100mm Button Bolt (63)–3
M6 x 22mm Button
Screw (29)–4
M6 x 38mm Button
Bolt (14)–7
M10 Split
Washer (17)–10
M10 x 25mm Button
Screw (71)–10
M8 x 38mm Button
Bolt (24)–4
M4 x 16mm
Screw (21)–3
M6 Nylon
Locknut (15)–4
M10 Nylon
Locknut (45)–2
Console Back
Screw (20)–5
Console
Screw (35)–4