Filter
Top Products
ASSEMBLY
Place all parts of the R-930 in a cleared area and remove the packing materials; do not dispose of the pack-
ing materials until assembly Is completed. Assembly requires a phillips screwdriver _ (not
Included),
1. Rrmly hold the Seat Tuba (2) with one hand and
the Handlebar Frame (3) with the oth.er hand. Lift
the Seat Tube and pivot the Handlebar Frame to
the position shown at the dghL
Make sure that there are two Handlebar Bushings
(41) In the upper end of the Handlebar Frame (3).
Slide the Handlebar (4) Into the Handlebar Frame.
The Handlebar must be tumed as shown. Tighten
the four #8 x 1/2" Screws (35) into the Handlebar
Frame and the Handlebar.
Pivot the Console Bracket (12) to the position
shown.
Push the Resistance Knob (6) onto the shaft on
the Resistance Cylinder (5).
2. Locate the Cordage Bolt (9) attached to the under-
side of the Seat (7). Insert the Carriage Bolt down
into the slot in the Seat Frame (2). Thread the
Seat Knob (11) with the 3/8- Washer (42) on'tothe
Carriage Bolt. Slide the Seat to the desired posi-
• tion and tighten the Seat Knob.
3. The Console (13) requires two =AA" batteries (not
included). Alkaline batteries are recommended.
See the inset drawing. Open the battery cover on
the back of the Console. Insert two batteries into
the Console. Make sure that the negative (-)
ends of the batteries are touchlng the springs
in the Console. Close the battery cover.
Connect the Reed Switch Wire (33) to the wire on
the Console (13). Feed any excess wire into the
Seat Frame (2). Insert the Conso!e into the
Console Bracket (12) until the tab on the Console
snaps into the hole in the Console Bracket.
2
2
4