Filter
Top Products
MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise
cycle regularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
PULSE SENSOR TROUBLESHOOTING
For optimal performance of the pulse sensor, keep the
metal contacts clean. The contacts can be cleaned
with a soft cloth--never use alcohol, abrasives, or
chemicals.
Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings. Do not hold the metal contacts too
tightly; doing so may interfere with heart rate read-
ings. For the most accurate heart rate reading, hold
the metal contacts for about 15 seconds.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left side shield must be removed.
First, remove the five M4 x 25ram Screws (39) from
the Right Side Shield (16). Next, remove the M4 x
12mm Screw (57) from the right side of the Side
Shield Cover (17).
16
57
39
Using an adiustable wrench, turn the Left Pedal (20)
clockwise and remove it, Next, remove the two M4 x
t6mm Screws (40) from the Left Side Shield (15) and
the M4 x 12ram Screw (57) from the Side Shield
Cover (17). Lift off the Side Shield Cover and the Left
Side Shield.
57
2O
Next, locate
the Reed
Switch (46).
Turn the left
arm of the
Crank (14)
until the
Magnet (58) is
aligned with
the Reed
Switch.
Loosen, but
do not
remove, the indicated M4 x 16mm Screw (40). Slide
the Reed Switch slightly closer to or away from the
Magnet. Retighten the Screw. Turn the Crank Arm for
a moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the left side shield, the side shield cover,
and the left pedal.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, refer
to assembly step 8 on page 6 and remove the con-
sole from the upright. Next, refer to step 7 and insert
three batteries into the console. Reattach the console
to the upright. Be careful not to pinch the wires or
the cable.
11