Filter
Top Products
11. Slide the Left Upright Cover (80) onto the Left
Upright (84) and the Right Upright Cover (86)
onto the Right Upright (85).
84
85
12. With the help of a second person, hold the con-
sole assembly (A) near the Right Upright (85)
and the Left Upright (not shown). Insert the
Upright Wire (87) into the hole in the bottom of
the Right Handrail and out of the end as shown.
Connect the Upright Wire (87) to the console
wire (C), See the inset drawing. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
Set the console assembly (A) onto the Right
Upright (85) and the Left Upright (not shown). Be
careful not to pinch any wires.
Insert the wires into the Right Handrail (83).
Press a Handrail Cap (63) into the end of the
Right Handrail and the Left Handrail (not shown).
Make sure the console wire (C) fits in the notch
in the right Handrail Cap.
12
Notch
63
87
Wire
Tie
A
12