Filter
Top Products
7
2. Orient the Right Upright (36) so the square hole near the
l
ower end is in the position shown. Attach the Right
Upright to the Upright Base (48) with two Upright Bolts
(
40) and two Upright Star Washers (39).
D
o not tighten
the Upright Bolts yet.
Attach each Wheel (45) to the Upright Base (48) with a
W
heel Bolt (89), two Wheel Spacers (44), and a Nut (47)
a
s shown.
D
o not overtighten the Wheel Bolts;
t
he
Wheels should turn freely.
48
Square Hole
45
47
44
89
45
44
3
6
44
89
47
2
3. Cut the tie securing the Wire Harness (28) in a bundle. Do
not remove
the large colored tie on the end of the
Wire Harness.
Orient the Upright Base (48) so the Wheels (45) are at the
bottom. Next, position the Upright Base and the Uprights
(31, 36) around the frame assembly as shown.
Have another person lift the front of the frame assembly
and hold it. Insert the Wire Harness (28) into the square
hole near the lower end of the Right Upright (36) and out
of the top. Next, raise the Uprights (31, 36) so the Upright
Base (48) is flat on the floor. Make sure that the end of
the Wire Harness does not fall into the Right Upright;
it may be helpful to hold the colored tie on the end of
the Wire Harness.
28
Colored Tie
48
28
36
45
3
4. Open the included grease packet, and apply grease to
both sides of each Frame Spacer (34).
Hold one of the Frame Spacers (34) between the frame
assembly and the Right Upright (36); make sure that
the Frame Spacer is oriented as shown in the inset
drawing.
Insert a Frame Bolt (32) through a Frame
Washer (33), the Right Upright, the Frame Spacer, and
the bracket on the frame assembly. Be careful not to
pinch the Wire Harness (28) in the Right Upright.
Tighten a Nut (47) several turns onto the Frame Bolt, but
do not fully tighten the Nut yet.
Repeat this step on the left side. Note: There is not a
wire harness on the left side.
Remove the colored tie from the Wire Harness (28).
Frame Assembly
Bracket
Frame Assembly
Hole
32
34
33
4
47
28
36
Right
Side
Left
Side
34
40
39
31