ProForm 595Pi Treadmill User Manual


 
8
28
11
6. Hold the Console Base (26) near the Right Handrail (11).
Attach the end of the ground wire on the Console Base
to the indicated small hole in the Handrail with a Silver
Ground Screw (27).
Connect the Wire Harness (28) to wire harness on the
Console Base (26). Make sure to connect the connec-
tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. If
the connectors do not slide together easily and snap into
place, turn one connector and try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
27
26
Ground
Wire
22
7. Set the console assembly on the Handrails (11, 18); in-
sert the excess wiring down into the Right Handrail.
Attach the console assembly with four 3/4” Screws (2),
two Console Bolts (22), and two 1/4” Star Washers (21)
as shown.
Make sure that no wires are pinched. Start
all four Screws and both Console Bolts before tight-
ening any of them.
2
21
2
11
18
6
7
5
. Identify the Right Handrail Endcap (91), which does
n
ot
have a cutout in the bottom, and slide it onto the lower
end of the Right Handrail (11). Make sure that the screw
hole in the Right Handrail Endcap is at the bottom. Next,
h
old the Right Handrail near the Right Upright (36), and
insert the Wire Harness (28) into the hole in the bottom
of the Handrail and out of the indicated hole in the top.
Then, remove the tie from the Wire Harness.
Set the Right Handrail (11) on the Right Upright (36)
while sliding the lower end of the Handrail onto the
bracket on the Right Upright. Hand tighten two Handrail
Bolts (20) with two Handrail Star Washers (19) into the
Handrail and the Right Upright. Next, slide the Right
Handrail Endcap (91) against the Right Upright, and
tighten an Endcap Screw (95) into the Right Handrail
Endcap. Then, tighten the two Handrail Bolts.
Make
sure that the Wire Harness (28) is not pinched.
Attach the Left Handrail (18) and the Left Handrail
Endcap (90) to the Left Upright (31) as described above.
36
31
95
95
91
90
Cutout
28
2
0
19
18
19
20
11
5
28
Console Assembly
21
22