Filter
Top Products
ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated
with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
rubber mallet , adjustable wrench , and wire cutters .
For help identifying the assembly hardware, see the drawings below.
If a part is not in the parts bag, first
check to see if it has been pre-assembled. To avoid damaging plastic parts, do not use power tools for as-
sembly.
1. Make sure that the power cord is unplugged.
Have a second person hold the Upright Base (48) in the
position shown, with the wheel holes at the top. Next, lo-
cate the Left Upright (31), which has an identification
sticker. Orient the Left Upright so the sticker is on the in
-
side as shown and the bracket is in the position shown.
Attach the Left Upright (31) to the Upright Base (48) with
two Upright Bolts (40) and two Upright Star Washers
(39). Do not tighten the Upright Bolts yet. Note: There
may be left and right stickers on the Upright Base.
Nut (47)–4
Handrail Bolt (20)–4
Upright Bolt (40)–4
Frame Washer
(33)–2
1/4” Star Washer
(21)–2
Silver Ground
Screw (27)–2
Wheel Spacer (44)–4
Console
Bolt (22)–2
Frame Bolt (32)–2
Wheel Bolt (89)–2
3/4” Screw (2)–4
Endcap Screw
(95)–2
F
Upright Star
Washer (39)–4
Handrail Star
Washer (19)–4
48
Wheel Holes
Sticker
Bracket
40
39
31
1
6