Filter
Top Products
12
13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see
pages 23 and 24).
12. Attach the Latch Housing (71) to the Left Upright
(73) with two #10 x 1" Tek Screws (76). Make
sure that the large hole in the Latch Housing
is on the side shown. Do not overtighten the
L
atch Screws.
Locate the Latch Assembly (72). Remove the
knob from the pin. Make sure that the collar and
t
he spring are on the pin. Then, insert the pin
into the Latch Housing (71), and tighten the
knob back onto the pin.
76
Spring
Knob
71
12
73
72
Collar
Large
Hole
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated M4.2 x 16mm Screw (12)
and the Access Door (97) from the Console
Base (88).
2. Connect the wire on the receiver to the indi-
cated wire extending from the Console Base
(88). Hold the receiver so the antenna is ori-
ented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on
the Access Door (97) with the two included
small screws.
3. Make sure that no wires are pinched.
Reattach the Access Door (97) with the M4.2 x
16mm Screw (12). Discard the other wires in-
cluded with the receiver.
Receiver
97
Antenna
12
88
Wire
Small
Screws
Pin
Wire