Filter
Top Products
7
5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 17). To protect the floor or carpet
from damage, place a mat under the treadmill.
4. With the help of a second person, carefully tip the
Uprights (82) down as shown. Make sure that the
Extension Legs (103) remain in the Uprights.
Attach each Extension Leg (103) with two Short Screws
(101) as shown.
Next, tighten a Handrail Bolt (78) with a Handrail Washer
(96) into each Extension Leg (103) and Handrail (85) as
shown. Note: It may be necessary to move the Handrails
up or down to align the Handrails with the holes in the
Extension Legs.
With the help of a second person, carefully tip the
Uprights (82) back to the upright position.
4
101
96
78
101
82
82
96
78
103
103
82
85
85
3. Slide the upper end of a Handrail (85) into the right
Upright (82) as shown. Note: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to slide it fully into the Upright. Next, pivot
the lower end of the Handrail down, push it toward the
right Upright, and then align it with the indicated hole.
Slide the other Handrail (85) into the left Upright (82) as
described above.
82
85
85
82
Hole
3
B
A