Filter
Top Products
24
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the consoleʼs
s
peakers, you must connect your MP3 player, CD
player, or other personal audio player to the console.
Locate the audio wire. Plug one end into the audio jack
on the side of the console. Then, plug the other end
into a jack on your MP3 player, CD player, or other
personal audio player. Make sure that the audio wire
is fully plugged in.
Next, press the Play button
on your MP3 player, CD
player, or other personal
audio player. Then, adjust
the volume level on your
personal audio player or
press the Volume increase
and decrease buttons on
the console.
If you are using a personal CD player and the CD
skips, set the CD player on the floor or another flat sur-
face instead of on the console.
Note: The USB port on the side of the console is for
software updates only. Plug a USB drive into the USB
port only if instructed to do so by an authorized service
representative.
HOW TO USE THE SETTINGS MODE
The console features a settings mode that allows you
to connect your treadmill to your own wireless network
and to log in to your iFit Live account. The settings
mode also allows you to select a display language, to
select the unit of measurement, and to turn on and turn
off the display demo mode.
1. Select the settings mode.
Insert the key into the console (see step 1 on page
17). Next, select the start menu (see step 2 on
page 17). Then, press the i button in the lower right
corner of the screen to select the settings mode.
2. Select the wireless network mode.
Press the Wireless Network button on the screen.
You must have your own wireless network and an
8
02.11b/g router with SSID broadcast enabled
(hidden networks are not supported).
If your wireless network is unencrypted and
does not require a password, go to step 2a. If
your wireless network is encrypted and re-
quires a password, go to step 2b.
2a. Connect your treadmill to an unencrypted
wireless network.
Press the Connect button for the desired wireless
network. When the Disconnect button appears,
your exercise equipment is connected to the wire-
less network. Then, press the Done button. Go to
step 3.
2b. Connect your treadmill to an encrypted
wireless network.
To connect to your encrypted network, press the
Connect button for the desired wireless network.
Enter your password in the Key/Passphrase entry
box and then press the Submit button.
To use numbers or other characters on the key-
board on the screen, press the .?123 button or the
#+= button. To return to the letter keyboard, press
the ABC button. To capitalize a character, press
the button with an upward-facing arrow. To clear
the last character, press the button with a back-
ward-facing arrow and an X.
To use advanced settings, press the Advanced
button for the desired wireless network.
To use a static IP address, press the Use Static
IPs button. Enter the IP address, netmask, gate-
way IP address, and at least one DNS. Press the
arrow buttons to view additional entry boxes. When
you are finished, press the Submit button. To re-
turn to the advanced settings screen, press the
Cancel button.
Volume Decrease
Volume Increase