Filter
Top Products
20 Assembling and Maintaining UBK 800-Series Upright Exercise Bikes
Installing the Handlebars
After the upright support and the bottle holder are securely in
place, install the handlebar assembly and route the heart rate
sensor cable through the support.
To install the handlebars:
1. Position the handlebars over the brackets near the top of
the upright support, as shown in the following illustration.
The open ends of the assembly should face up and
forward.
Figure 8: Installing the handlebars
2. Feed the heart rate cable through the nearest end of the
bracket and into the upright support.
3. Have your assistant pull the end of the heart rate cable
through the console mount at the top of the upright
support.
4. Place four ⁵₁₆-inch flat washers onto four ⁵₁₆-inch x
³₄-inch sockethead screws. Place the handlebar assembly
onto the brackets and attach the four sockethead screws
with their washers. Tighten the screws completely using a
¹₄-inch hex wrench.