Filter
Top Products
Assembling the Exercise Bike 17
4. Remove the four #10 x 1-inch self-tapping screws holding
the left side cover in place, then pull the cover away from
the body assembly. Guide the cover around the pedal
crank, then remove it and set it aside.
Figure 4: Side cover removal
5. Remove the tape holding the base unit data cable in place
inside the upright support channel.
6. Slide the jack panel up and out of its bracket in the right
side cover.
To install the upright support and prepare the cables for
connection to the console:
1. Attach the lower ends of the following cables to the inner
side of the jack panel:
Ethernet cable
Television cable (for P80 console)
Power cable (for P80 console)
2. Slide the jack panel back into its bracket in the right side
cover.
3. Using a piece of tape or a plastic tie, bind together the
upper ends of all cables.
4. While your assistant holds the upright support in place
over the body assembly, thread the cables upward
through the support. When you are finished, use a piece
of tape to secure the upper connectors of the cables at
the top of the support.
5. Slide the upright support into position so that its screw
holes line up with the corresponding holes on the body
assembly, as shown in the following illustration.