Filter
Top Products
S3.25 Leg Press Option Assembly Instructions
page 18
1 2 3 4 5 6
A
B
Adjust the
Rubber Bumper
Push the Pivot Arm up to adjust
the Rubber Bumper
Rubber Bumper
Locknut
Bracket
C
Weight Pin
3. Adjust the Rubber Bumper on
the Leg Press Option
If the Top Cap Weight still does not rest on the Top
Weight, you can make one final adjustment.
A. If the Cable tension still needs adjusting, push the
Pivot Arm up so that you can adjust the Rubber
Bumper on the Leg Press Option.
B. Rotate the Rubber Bumper up or down to tighten
or loosen the Cable tension.
Important: Tighten the locknut against the bracket
after you have properly adjusted the Cable tension.
C. Check the weights. Move the Weight Pin to each
Weight and Selector Stem location and replace the
Weight Pin in the Weight Stack.
With the slack removed from the Cables, you are now
ready to use the Leg Press Option. Thank you for
choosing Precor Strength-Training Equipment.
Note: For maintenance instructions, refer to your
S3.25
Assembly and Maintenance Guide.
Step 3. Adjust the Rubber Bumper on the Leg Press Option