Filter
Top Products
S3.25 Leg Press Option Assembly Instructions
page 16
1 2 3 4 5 6
4
Adjustments
Adjustments
B
A
Top Cap
Weight
C
Chest Press Arms
Weight Pin
Top Cap Weight
Top Weight
After the Leg Press Option is assembled, you should
check the Cables for proper tension. These are some
obvious signs that cable problems exist:
✔ Excess slack exists in the Cable.
✔ The Top Cap Weight does not rest squarely on the
Weight Stack.
✔ The Cable rubs the inside edges of the pulleys.
CAUTION: Take the time to perform the following
steps. If the Cables do not have
the proper tension, you could damage the
machine and void the Precor Limited Warranty.
Note: To adjust the Selector Stem, refer to the
S3.25 Assembly and Maintenance Guide
.
1. Stretch the Cable
A. Sometimes a new cable must be stretched so that
the Top Cap Weight rests on the Weight Stack. To
lengthen the Cable, insert the Weight Pin at a
comfortable weight level.
B. Push up on the Chest Press Arms, and then slowly
lower them.
C. Make sure the Top Cap Weight rests squarely on
the Weight Stack. If it does, no more adjustments
are needed, and the Leg Press Option is ready to
use. If the Top Cap Weight does not rest on the Top
Weight then further adjustments are needed.
Continue with steps 2 and 3.