Filter
Top Products
S3.15 Multi-Hip Option Assembly Instructions
page 10
1 2 3 4 5 6
4. Attach the Multi-Hip Cable to
the S3.15
A. Attach the end of the Multi-Hip Cable to the S3.15
Cable using
one 1-inch hex head bolt
one locknut
B. Wrench tighten the locknut, but do not bend the
flanges.
C. Position the Pivoting Bracket to align the cables.
If necessary, loosen the fastener securing the
Pivoting Bracket to the Main Base. Retighten the
fastener after aligning the cables.
This completes the assembly of the Multi-Hip Option.
Before using the Multi-Hip, check the cable tension
throughout the S3.15 unit. Refer to
Cable Adjustments
and Maintenance
in the
S3.15 Assembly and
Maintenance Guide
.
Step 4. Attach the Multi-Hip Cable to the S3.15
A
1 - 1" bolt
1 - locknut
B
C