Filter
Top Products
22 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
Connect … To …
The console power
cable
The power cable assembly
The Ethernet cable The eight-connector modular jack on the
jack panel
The television cable The coaxial connector on the jack panel
Note: This cable must be wrench tightened.
4. Repeat steps 1 through 3 until all three cables are
completely installed.
5. Insert all cables into the cable clips on the center frame
pillar just below the bottom of the center column. Use
plastic ties to bind the cables together below the clips and
to route them away from any moving parts.
Replacing Access Covers
After you install the console cables, you can return the access
covers to their previous positions on the equipment.
To replace the access covers:
1. Snap the front cover back into place. Reinsert the two
buttonhead screws you removed with the front cover,
then tighten them using a ⁵₃₂” hex wrench.
2. Position the top column cover between the handlebars
and the body of the AMT. Make sure that the sides of the
top column cover extend over the upper edges of the
body covers, then use the heel of your hand or a rubber
mallet to tap the cover back into place.
Leveling the AMT
It is important that you level and stabilize the AMT properly
every time you move it.
CAUTION: To eliminate movement, make sure the adjustable feet
are in contact with the floor. Also, make sure that the unit sits on
a flat surface. Adjusting the feet of the unit cannot compensate
for extremely uneven surfaces.