Filter
Top Products
20 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
Removing Access Covers
With its access covers removed, the AMT provides easy
access to its cables and internal components.
Tip: In the following procedure, set aside the covers and their
mounting hardware in groups, in the order in which you
remove them. This simplifies reinstallation later.
To remove the access covers:
1. Using a rubber mallet or the heel of your hand, tap at an
upward angle against the side of the top column cover to
snap it loose.
Figure 6: Where to place pressure when removing top cover
2. Lift the cover, then slide it toward the rear of the
equipment and out.
3. Using a ⁵₃₂” hex wrench, disconnect the two 1-inch
buttonhead screws at the bottom of the front cover, then
snap the cover loose.