Filter
Top Products
30 Assembling and Maintaining the EFX 821 Elliptical Fitness Crosstrainer
Completing the Console Installation
Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
Note: During these steps, you will need the four ³₄-inch
flat-head screws that were packed with the console.
To complete the installation:
1. Tilt the control console backward (toward yourself) until
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
2. Insert the four ³₄-inch flat head screws through the holes
in the console mount and thread them into the holes in
the back plate on the console. Tighten the screws fully
using a ⁵₃₂-inch hex wrench.
3. Line up the two small tabs at the bottom of the console’s
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
4. Insert the two #8–32 x ¹₂" #2 Phillips-head screws that
you removed earlier into the holes at the top edge of the
console’s back cover. Tighten the screws fully.
5. If necessary, reinstall any body panels you have removed
from the base unit.