Filter
Top Products
CW-113 Assembly and Maintenance Guide
page 9
Assemble the Unit, continued
5. Pull on the Adjustment Pin and slide the Back
Adjustment through the Main Frame. Release the
Adjustment Pin while it is aligned with the Back
Adjustment middle hole.
Note: Make sure the Springs slide onto the posts
on the bottom of the Back Support
6. Slide the Sleeve through the Back Support. Align
the holes and attach the Back Support to the Main
Frame using
one 5¼-inch buttonhead screw (E)
two ½-inch washers (F)
one ½-inch locknut (G)
Wrench tighten using a ¾-inch open end wrench.
7. Attach the Holder Assembly to the Back Support
using
four ¾-inch buttonhead screws (A)
four ³⁄₈-inch split washers (B)
Wrench tighten.
4 - ¾" buttonhead screws
4 - split washers
1 - 5¼" buttonhead screw
1 - sleeve
2 - washers
1 - locknut
Sleeve