Filter
Top Products
CW-113 Assembly and Maintenance Guide
page 10
Assemble the Unit, continued
Roller Bar
8. Slide the Roller Bar through Holder Assembly, and
then place a Round Cap onto each end of the
Roller Bar. Slide the Round Caps against the
Holder Assembly.
9. Slide a Roller Pad onto each end of the Roller Bar,
followed by a Roller Cap. Place an Aluminum Cap
on each end of the Roller Bar and tighten the set
screws.
10. Tighten the set screws at the end of the Holder
Assembly to secure the Roller Bar, then insert the
Square Cap into the Holder Assembly.
11. Insert a Round Cap into each end of the
Handlebar, and then slide the Handlebar through
the Holder Assembly. Slide a Grip onto each end of
the Handlebar, then secure the Handlebar to the
Holder Assembly by tightening the set screws with
a
3
⁄32-inch Allen wrench.