Filter
Top Products
C846i/C842i Recumbent Cycle Assembly Guide 5
Level the cycle.
Before allowing users on the cycle, make sure it does not wobble
from side to side.
To remove any side-to-side movement, take the following steps.
1. Ask your assistant to tip the unit on its side.
2. Locate the two height adjusters at the rear of the unit.
3. Rotate the height adjusters to raise or lower the unit.
Important: If the unit is placed on a slightly uneven surface,
rotating the height adjusters can help, but will not compensate
for extremely uneven surfaces.
4. When you are finished adjusting the cycle, ask your assistant to
gently lower the unit to the floor.
Height adjusters
Verify that the C846i heart rate display is operational.
Note: To check the heart rate display on the C842i, you need to wear a
chest strap and skip step 2.
1. Sit on the cycle. When you are comfortably situated, begin pedaling.
Pedaling above 20 revolutions per minute (RPM) must be
maintained for several seconds.
2. Grasp both touch-sensitive handlebar grips.
3. Look at the HEART RATE display. After a few seconds, a number
appears indicating your heart rate.
Note: If a number does not appear in the HEART RATE display, you
may need to disassemble the unit and check the cable connection. For
troubleshooting tips, refer to the Product Owner’s Manual.