Filter
Top Products
16 Assembling and Maintaining the 835 Climber
4. Insert the handlebar flange onto the screws protruding
through the handrail clamp). Rotate the handlebar to align
it with the side screw holes.
CAUTION: Hold the handlebar upright until it is securely
fastened in step 6.
Figure 3: Threading the heart rate cable and moving the
handlebar into place
5. Thread the two hex nuts and washers (removed earlier)
back onto the screws.
Important: Do not tighten the two hex nuts at this time.
6. Attach and fully tighten two buttonhead screws to secure
the handlebars, as shown in the following illustration.
Figure 4: Securing the handlebars in place