Filter
Top Products
52
TURN THE SOUND SIGNAL AND THE
BUTTON SOUND ON/OFF
When appears in the display, you will hear an
alarm sound with each heart beat if you go above the
upper limit or below the lower limit of your Target
Zone. You will hear a beep when pressing the
buttons. The sound signal will be on in OwnZone
determination.
In models M61 and M62 the sound signal will also
alarm you at the end of the Fitness test.
Press and hold
for 2 seconds to turn the sound
signal and the button sound on and off.
Sound signal is on.
A flashing heart rate reading also informs you
of being outside your target zone.
The sound signal setting is saved i.e. the next
time you start heart rate measurement the
previous setting will be used.
SWAP THE USER
In models M61 and M62 you can swap the user in
the beginning of an exercise when the stopwatch is
not running yet.
To be able to swap the user you need to set
preferences for two users.
Press and hold
Up
or is displayed to indicate which one of
the user settings are activated.
The following exercise will be recorded in the
selected user’s file.
START/STOP THE STOPWATCH
Press START/STOP/OK to start/stop the stopwatch.
Exercise information will be stored in an
exercise file only when the stopwatch is
running.
You can pause the stopwatch by pressing START/
STOP/OK. Repressing it will restart the stopwatch
and the above calculations.
To reset the stopwatch to zero:
1. Stop the stopwatch.
2. Press and hold Down.