Filter
Top Products
893102 PROSYSTEM ASSEMBLY INSTRUCTIONS
17. LOW PULLEY CABLE ROUTING ASSEMBL Y (SEE CABLE ROUTING DIAGRA3~I)."
18.
19.
20.
ho
Eo
Route CABLE (657620 i) under and around the PULLEYS at the bottom of the UPRIGHT
FRAy’vIE WELDMENT. (NOTE: AFTER CABLE HAS BEEN ROUTED UNDER
PULLEY, POSITION CABLE RETAINING CLIP UNDER THE PULLEY AS SHOWN
AND TIGHTEN)
Route CABLE up and around the bottom PULLEY of the 1-3/4 X 5-1/4 IN. PLATES as shown.
and down to, and around the PULLEY under the PULLEY BRACKET WELDMENT. (SEE
NOTE ABOVE)
Assemble the end of the CABLE to the PULLEY BRA CKET WELDMENT as shown.
SECURELY assemble the appropriate HARDWARE to the hole below the front PULLEY at the
bottom of the UPRIGHT FRAME WELDMENT as shown.
SEC.URELY tighten all remaining PULLEY CONNECTIONS.
Slide the 1 X 8 IN. GP, dPS over the ends of the LATBAR WELDMENT and LOWROWBAR
WELDMENT as-shown. (TIP: USE WINDOW CLEANER ON TIlE INSIDE OF TIlE GRIPS TO
HELP EASE ASSEMBLY)
SEE CABLE ROUTING DIAGRAM FOR THE COMPLETE USE AND LOCATION OF THE
LA T BAR WELDMENT, CHAIN, AND LOWROWBAR.
Attach the UP1KIGHT LABELS to the UPRIGHT WELDMENTS as shown.
6
12/06/95