ParaBody 887 Home Gym User Manual


 
5
FIGURE 2
STEP 2:
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
LOOSELY assemble the PULLEY HOUSING (3) and the UPRIGHT (1) to the LOWER CROSS SUPPORT using two 3/8 X 4” BOLTS
(38), four 3/8” WASHERS (30), and two 3/8” LOW HEIGHT LOCK NUTS (29). See FIGURE 2.
3/8 X 4” 38
3/8” LOW HEIGHT LOCK NUT 29
3
16
LOWER CROSS SUPPORT
1
UPRIGHT FRAME
30
30
NOTE: It may be necessary to loosen the 1/2 X 3-1/4” BOLTS of the LOWER CROSS SUPPORT connecting the UPRIGHT
FRAME before beginning STEP 2.
Insert one 2” SQ. END CAP (16) into the end of the PULLEY HOUSING (3) as shown in FIGURE 2.
• Attach four 3/4 X 1-1/2” GLIDES (24) to the inside of the tube on the UPRIGHT (1) as shown in FIGURE 2 using the follow-
ing steps:
• Thoroughly clean all surfaces where the 3/4 X 1-1/2” GLIDES (24) are to be attached.
• Remove the 3/4 X 1-1/2” GLIDES (24) from the paper backing and firmly apply them to all shown surfaces.
SECURELY assemble one SPRING PIN ASSEMBLY (21) to the spring pin barrel on the UPRIGHT (1). See FIGURE 3.
21
24