Filter
Top Products
868 .WEIGHT STACK OPTION ASSEMBLY INSTRUCTIONS
14. To assemble the WEIGHT STACK CABLE, follow the cable routing diagram on drawing, and use the
following steps:
Route the threaded end of the WEIGHT STACK CABLE over the HIGH PULLEY between the
PULLEY MOUNT FLATS. Then reassemble the one (1) 3/8 X 3-1/4 IN. BOLT and REL?~TED
HARDWARE to the hole in front of the HIGH PULLEY (IF NECESSARY). (DO NOT OVER
TIGHTEN BOLT) (MAKE SURE THAT THE CABLE IS BETWEEN THE PULLEY AND
BOLT)
Continue the CABLE down to the SECOND PULLEY between the PULLEY MOUNT FLATS.
Pull the CABLE over this PULLEY and down to the PULLEY BLOCK.
¯
Continuethe CABLE around the TOP PULLEY of the PULLEY BLOCK and up to the PULLEY
of the TOP SUPPORT WELDMENT above the WEIGHT STACK..
Continue the CABLE over and down this PULLEY to the WEIGHT STACK, and SECURELY
assemble the CABLE to the WEIGHT STACK SHAFT of the HEAD PLATE as shown i~a the
CABLE ROUTING DIAGRAM.
¯
See CABLE ROUTING DIAGRAM for help in completing this step.
15. Attach the WEIGHT STACK LABELS to the WEIGHT STACK as shown on drawing.
16. To select WEIGHT, rotate the WEIGHT STACK SELECTOR PIN clock wise 90 degrees, inse;t into the
slot of the desired WEIGHT PLATE, and rotate the PIN back down.