Filter
Top Products
824101 LEG CURL/EXT ATTACHMENT ASSEMBLY INSTRUCTIONS
Insert one (1) 1-3/4 IN. SQ. END CAP into the top of the LEG EXTENSION NECK as shown
drawing.
Slide t~vo (2) ROLLER PADS over each end of the SHAFT of the LEG EXTENSION NECK,.
shown on drawing, and hold in place using two (2) 3/4 IN. STARLOCK COLLARS.
3. Insert three (3) 1-3/4 IN. SQ. END CAPS into the ends of the LEG EXTENSION as stm~ on drawing.
Insert two (2) 1/2 IN. FLANGE BEARINGS into the BUSHING on the LEG EXTENSION as shown
drawing.
Assemble the LEG EXTENSION NECK to the LEG EXTENSION as shown on drawing, using one (1)
1/2 X 3 IN. BOLT, two (2) 1/2 IN. WASHERS, and one (1) 1/2 IN. LOW HEIGHT LOCK
(TIGHTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ..ALLOWING THE
LEG EXTENSION TO ROTATE FREELY)
Assemble four (4) ROLLER PADS to the LEG EXTENSION as shown on drawing, using two (2)
ROLLER PAD SHAFTS, and four (4) 3/4 IN. STAR LOCK COLLARS.
Attach one (1) 3/4 IN. SQ. RUBBER BUMPER to the LEG EXTENSION approximately where shoxvn
on drawing.
To perform LEG CURLS or LEG EXTENSION, insert the LEG EXTENSION ASSEMBLY into the
UPRIGHT TUBE of the BENCH FRAaME as shown on drawing, and tighten in place using the
THUMBSCREW. To adjust the SEAT PAD for the LEG EXTENSION position, pull out on the U-
PIN. l~otate the U-PIN back pass the FIRST PIN STOP. P, elease the U-PIN, and allow it to rest up
against the FIRST PIN STOP.
3
04115/97