Filter
Top Products
23
FIGURE 28
ADJUSTMENT
• Adjustments can be made in the above locations to set the correct amount of tension in the cables.
ADJUSTMENT
ADJUSTMENT
STEP 28:
9
23
9
• If upon completion of assembly, the HEAD PLATE (23) does not sit on top of the first WEIGHT PLATE (21), push the HEAD
PLATE (23) down, insert the WEIGHT STACK PIN (27) and perform several repetitions. This will relax the cable system and
prevent the HEAD PLATE (23) from lifting up. See FIGURE 28
• If after completing the previous step, the HEAD PLATE (23) still does not sit on top of the first WEIGHT PLATE (21) or if
there is excess slack in the cable system, adjust the threaded ends of the CABLES attached to the PULLEY BRACKETS (9)
accordingly and retighten the jam nuts. See figure 28.
• For maximum performance, the HEAD PLATE (23) should just barely sit on the top WEIGHT PLATE (21)
Thank you for purchasing the ParaBody 777101 Gym System. If unsure of proper use of equipment, call
your local ParaBody distributor or call the ParaBody customer service department at (800) 328-9714
• NOTE: After making adjustments make sure all jam nuts are SECURELY TIGHTENED!
• This completes the assembly of the 777 Gym System. If the 777 SHROUD OPTION was purchased proceed to STEP 29.