Filter
Top Products
607/608
FACTOR 625 D-RING RETRO KIT ASSEMBLY INSTRUCTIONS
STEP 1: D-RING’INSTALLATION
1.
To assemble the new D-RING to the FACTOR 625, use the following steps:
¯
Remove all the CABLES from the old D-RING.
¯
Loosen, and remove the two (2) 1/4-20 NUTS, and the 1/4 IN. WASHER from the end of the
RING CABLE.
¯
Slide one (1) VINYL CAP over the end of the new D-RING.
¯
Remove and discard old D-RING, and replace with the new D-RING.
¯
LOOSELY attach the 1/4 IN. WASHER, and the two (2) 1/4 IN. NUTS to the end of the D..RING
CABLE. (POSITION THE 1/4-28 NUTS HALF WAY UP ON THE THREADS OF TIlE D-
RING CABLE UNTIL CABLE INSTALLATION IS COMPLETE. DO NOT TIGI-][TEN NUTS
AT THIS TIME)
STEP: 2 CABLE INSTALLATION
NOTE: FOR EASE OF CABLE REPLACEMENT THE D-RING END OF THE OLD CABLES MAY BE
CUT OFF. IF THIS IS NOT POSSIBLE SOME PULLEYS WILL NEED TO BE LOOSENED AND
REMOVED TEMPORALLY IN ORDER TO REMOVE OLD CABLES.
To replace the ROTARY CABLE (6406001), or (depending on which RETRO KIT being assembled)
the LEG PRESS/ROTARY CABLE (6405701), see the drawing, and use the following steps:
¯
Remove the SHOCK CORD from the BASE of the 625, then remove it from the end of the old
ROTARY CABLE.
¯ Remove and discard the old ROTARY CABLE, and replace it with the new ROTARY CABLE.
(THE CABLE MUST BE ROUTED THE SAME WAY IT WAS REMOVED).
¯
Run the ROTARY CABLE through the hole of the D-RING shown in (DETAIL A )on drawing, and
attach one (1) D-RING CABLE CLIP around the ball end of the ROTARY CABLE.
¯ Attach one (1) SHOCK CORD to the D-RING CABLE CLIP on the end of the ROTARY CABLE
as shown in (DETAIL A).
¯
Route the SHOCK CORD the same way that it was removed. Attach one (I) SWIVEL to the end
the SHOCK CORD, and slide the swivel over the BAR on the BASE as shown in (VIEW B-B).
Replace the SHOCK CORD to its original position on the BAR
¯ IMPORTANT: MAKE SURE THAT THE D-RING CABLE CLIP IS POSITIONED
VERTICALLY ABOVE THE D-RING.