Filter
Top Products
4
STEP 4:
FIGURE 3
HEAD PLATE
• SECURELY assemble the 20 HOLE WEIGHT STACK SHAFT
(1) to the HEAD PLATE. (NOTE: The bolt hole in the HEAD
PLATE should be on top.)
• Attach the WEIGHT STACK LABELS (3) (#16-20) to the
five WEIGHT PLATES (4) as shown on FIGURE 3.
• Insert the two GUIDE RODS through the two WEIGHT
STACK CUSHIONS into the base as shown in FIGURE 3.
Lubricate the GUIDE RODS with a silicon or teflon
spray that is available at most hardware stores.
•
USING EXTREME CARE, slide the five new WEIGHT
PLATES (4) and the previous fifteen WEIGHT PLATES
down over the GUIDE RODS onto the WEIGHT STACK
CUSHIONS. (NOTE: Make sure that the key holes of the
WEIGHT PLATES all face the same way.)
• Carefully Slide the new HEAD PLATE ASSEMBLY down
over the GUIDE RODS onto the weight stack as shown in
FIGURE 3.
GUIDE ROD
WEIGHT
STACK
CUSHION
Thank you for purchasing the Parabody 359101 50 LB. ADD-ON KIT. If unsure of proper use of equipment, call your local
LifeFitness distributor or call the Parabody customer service department at (800) 328-9714.
4
3
• Screw the CABLE into the WEIGHT STACK SHAFT of the
HEAD PLATE until the CABLE slightly pulls on the HEAD
PLATE.
• TIGHTEN jam nut securely!
1
• SECURELY tighten all loose connections.