Filter
Top Products
6
3
5
V-shaped Groove
29
Grease
33
33
30
30
58
58
1
Tubes
Tubes
3. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an Incline Axle Screw (30). Tighten the Incline
Axle Screw into one end of the Incline Axle (29). Next,
apply a small amount of the included grease to the
Incline Axle.
Align the indicated tubes on the Incline Frame (5) with
the tubes on the Base (1). Make sure that the Incline
Frame is turned so the V-shaped grooves are on
top. Insert the Incline Axle (29) through the Incline
Frame and the Base. Note: It may be helpful to tap the
Incline Axle with a rubber mallet to insert it.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto the other Incline Axle Screw (30). Tighten the
Incline Axle Screw into the open end of the Incline Axle
(29).
2
Console
Wire
51
35
35
44
4
87
4. Remove the four Console Screws (35) and the four
Console Washers (44) from the Console (87).
Connect the console wire to the Harness Extension
(51).
Attach the Console (87) to the Upright (2) with the four
Console Screws (35) and the four Console Washers
(44) removed previously. Be careful to avoid pinching
the wires.
5. Remove the four M10 Nylon Locknuts (not shown)
from the welded bolts on the front of the Frame (1).
Lay a cloth over the front of the Frame (1) to protect it
from scratches. Lay the Upright (2) in the position
shown. Connect the Harness Extension (51) to the
Wire Harness (25).
2
1
51
25
5
Welded Bolts