Filter
Top Products
19
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 5 on page
5 for replacement instructions.
HOW TO LEVEL THE EXERCISE CYCLE
After the exer-
cise cycle has
been moved to
the location
where it will be
used, make sure
that both ends of
the front stabiliz-
er are touching
the floor. If the
exercise cycle
rocks slightly during use, turn one or both of the level-
ing feet under the front stabilizers until the rocking
motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
I
f the handgrip pulse sensor does not function properly,
see step 5 on page 11.
HOW TO MOVE THE EXERCISE CYCLE
To move the exercise cycle, hold the handle on the
rear stabilizer and carefully lift it until the exercise
cycle can be moved on the front wheels. Carefully
move the exercise cycle to the desired location and
then lower it.
MAINTENANCE AND TROUBLESHOOTING
Handle
Wheel
Leveling
Foot