Filter
Top Products
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. When the treadmill is in the location where it will be
used (see HOW TO MOVE THE TREADMILL below),
make sure that both Rear Feet (5) and both front
Wheels (not shown) rest firmly on the floor. If the tread-
mill rocks slightly, loosen the Rear Foot Locknut (111)
above the right Rear Foot. Turn the right Rear Foot
clockwise or counterclockwise until the rocking motion
is eliminated. Then, tighten the Rear Foot Locknut.
5
111
6
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
48
5
4. Refer to step 1. While a second person holds the
Uprights (95, 97), remove the two Upright Bolts (96).
Slide the Uprights (95, 97) fully onto the brackets on the
Frame (not shown). Be careful to avoid pinching your
hands or the Wire Harness (not shown). Attach each
Upright with four Upright Bolts (96) as shown. Firmly
tighten all eight Upright Bolts.
Firmly tighten the four Handrail Bolts (99).
99
91
91
95
96
96
96
97
4
HOW TO MOVE THE TREADMILL
Note: It may be helpful to leave the treadmill at an in-
cline before moving the treadmill.
Before moving the treadmill, make sure that the
power cord is unplugged from the wall outlet.
Due to the size and weight of the treadmill, moving it
requires two persons. While one person lifts the indi-
cated end, firmly hold the handrails and tip the treadmill
forward until it rolls on the front wheels. Carefully move
the treadmill to the desired location and then lower it.
CAUTION: To reduce the risk of injury, use extreme
caution while moving the treadmill. Do not attempt
to move the treadmill over uneven surfaces.
Lift
Here
Wheels
Handrails
7
5
111