Filter
Top Products
10
6. Set the Console Cover (87) on the Uprights (77,
79). Make sure that the Console Cover is ori-
ented with the ties toward the bottom as shown.
Attach the Console Cover (87) with the two #8 x
1 1/2" Screws (19) that you removed in step 4.
Start both Screws, and then tighten each of
them; do not overtighten the Screws.
Insert the Upright Wire (78) through the loops in
the ties.
6
Ties
87
79
19
78
77
5. Position the Console Crossbar (103) between
the Uprights (77, 79) as shown. Attach the
Console Crossbar to the Uprights with four 5/16"
x
2 3/4" Bolts (4) and four 5/16" Star Washers
(9); do not fully tighten the Bolts yet.
Remove the wire tie from the Upright Wire (78).
5
103
4
9
77
79
78
Wire Tie
4
9