Filter
Top Products
8
3. With the help of a second person, carefully tip
the incline trainer down so that the Base (78) is
flat on the floor.
Attach a Wheel (77) to each side of the Base
(
78) with a 3/8" x 2 1/2" Bolt (4) and a 3/8" Nut
(8) (only one side is shown).
3
4
8
77
78
4. Have a second person hold the Left Handrail
(69) near the Yoke (88). Locate the wire tie in
the left end of the Yoke. Tie the wire tie around
the Left Pulse Wire (70).
Pull the other end of the wire tie until the Left
Pulse Wire (70) is extending from the hole in the
center of the Yoke (88). At the same time, insert
the Left Handrail (69) into the Yoke. Make sure
not to pinch the Left Pulse Wire.
Attach the Left Handrail (69) to the Yoke (88)
with two 5/16" x 3/4" Bolts (6); do not fully
tighten the Bolts yet.
Repeat this step with the Right Handrail (75)
and the Right Pulse Wire (71).
4
6
70
75
6
71
88
Wire
Ties
69
5. Hold the Yoke Spacer (87) near the Upright
(74). Make sure that the curved side of the
Yoke Spacer is facing the Upright. Have a
second person hold the Yoke (88) near the
Upright. Insert the Upright Wire (72) through the
Yoke Spacer and the Yoke.
Curved
Side
74
87
88
72
5