Filter
Top Products
25
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in
length.
b. If the walking belt is overtightened, hiker performance
may decrease and the walking belt may become dam-
aged. Remove the key and UNPLUG THE POWER
CORD. Using the allen wrench, turn both front roller
adjustment bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 2 to
3 inches off the walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in-
sert the key and run the hiker for a few minutes.
Repeat until the walking belt is properly tightened.
c. If the walking belt still slows, please call our Customer Service Department, toll-free.
PROBLEM: The walking belt is off-center
SOLUTION: a. If the walking belt has shifted to the right, first remove
the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn each of the front roller adjustment bolts
1/4 of a turn in the direction shown. Be careful not to over-
tighten the walking belt. Plug in the power cord, insert the
key and run the hiker for a few minutes. Repeat until the
walking belt is centered.
b. If the walking belt has shifted to the left, first remove
the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn each of the front roller adjustment bolts
1/4 of a turn in the direction shown. Be careful not to over-
tighten the walking belt. Plug in the power cord, insert the
key and run the hiker for a few minutes. Repeat until the
walking belt is centered.
PROBLEM: The walking belt slips when walked on
SOLUTION: a. If the walking belt slips when walked on, first remove the
key and UNPLUG THE POWER CORD. Using the allen
wrench, turn both front roller adjustment bolts clockwise,
1/4 of a turn. When the walking belt is correctly tightened,
you should be able to lift each side of the walking belt 2 to
3 inches off the walking platform. Be careful to keep the
walking belt centered. Plug in the power cord, insert the
key and carefully walk on the hiker for a few minutes.
Repeat until the walking belt is properly tightened.
PROBLEM: The grade of the hiker does not change correctly or does not change when iFit.com CD’s and
videocassettes are played
SOLUTION: a. With the key in the console, press one of the Grade buttons. While the grade is changing, re-
move the key. After a few seconds, re-insert the key. The hiker will automatically rise to the high-
est grade and then return to the lowest grade. This will recalibrate the hiker.
b. If an “E6” appears in the Distance/Time display, remove the key and unplug the power cord. Wait
for sixty seconds and then plug in the power cord and re-insert the key.
2”–3”
b
a
b
a
Front Roller Adjustment Bolts