Filter
Top Products
8
9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware
may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat
under the elliptical crosstrainer.
2
18
Console
Wire
Harness
51
35
35
44
8
87
8. This step requires the help of a second person.
Remove the four Console Screws (35) and the four
M10 Flat Washers (44) from the Console (87).
Hold the Console (87) in the position shown and
connect the console wire harness to the Upper Wire
Harness (51). Remove the rubber band from the Upper
Wire Harness and push the Upper Wire Harness and
the console wire harness down into the Upright (2). Set
the Console on the Upright. Make sure that the con-
sole wire harness is not pinched between the
Console and the Upright.
Hold the Handlebar (18) in the position shown. Align
the four holes in the Handlebar with the four holes in
the plate at the top of the Upright (2). Attach the
Handlebar and the Console (87) to the Upright with the
four Console Screws (35) and the four Console
Washers (44) that you removed previously. Note:
Thread all four Console Screws into the Console
before tightening them.