Filter
Top Products
20
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip pulse sensor, or if the displayed
heart rate appears to be too high or too low, see step
5 on page 17.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical exerciser rocks slightly on your floor
during use, see HOW TO LEVEL THE ELLIPTICAL
EXERCISER on page 13.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. First, remove all of
the screws from the left outer and inner side shields;
there are two sizes of screws in the left outer and
inner side shields—note which size of screw you
remove from each hole. Then, gently remove the left
outer side shield.
Next, locate the Reed Switch (86). Turn the Pulley
(53) until a Magnet (88) is aligned with the Reed
Switch. Loosen, but do not remove, the indicated M4 x
16mm Screw (67). Slide the Reed Switch slightly clos-
er to or away from the Magnet, and then retighten the
Screw. Rock the Pulley forward and backward just
enough that the Magnet passes the Reed Switch
repeatedly. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjusted,
reattach the left outer and inner side shields. Note: If
you have questions regarding which screw should be
in which hole, see EXPLODED DRAWING A on page
25 and the PART LIST on page 24.
MAINTENANCE AND TROUBLESHOOTING
53
88
67
86