Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own flat-bladed screwdriver , wire cutters and adjustable
wrench .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the treadmill or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt or foot pads,
simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
6
2. With the help of a second person, carefully raise both
Uprights (99) to a vertical position. Press the Lock Knob
Sleeve (111) and the Lock Knob Spacer (112) into the left
Upright.
Remove the Lock Knob (113) from the Lock Pin (107).
Make sure that the Lock Pin Collar (109) and the Spring
(110) are on the Lock Pin. (Note: If there are two Lock Pin
Collars, place one on each side of the Spring.) Insert the
Lock Pin into the Lock Knob Sleeve (111) and the Left
Upright (99).
Tighten the Lock Knob (113) onto the Lock Pin (107).
99
112
111
113
110
109
107
2
1. Slide the treadmill out of the box. Insert the three Cage
Nuts (96) into the three indicated holes in the treadmill.
To insert each Cage Nut (96), first hook one side of the
Cage Nut into the hole and then use a flat-bladed screw-
driver to press the other side into the hole, as shown.
96
96
1
3. With the help of a second person, carefully raise the
Walking Platform (24) to the storage position and make
sure that the lock pin is properly engaged as described
on page 25.
Position the Base Plate (91) on the treadmill as shown.
Attach the Base Plate with the three Base Plate Screws
(92). Note: It may be helpful if a second person tips the
treadmill slightly as you tighten the Screws.
Carefully lower the Walking Platform (24) to the floor as
described on page 25.
91
24
92
3