Filter
Top Products
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 15), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Look under the Console (4) and locate the left water
bottle holder. Insert the tip of a flat-bladed screwdriver
between the side of the water bottle holder and the
Console in the location shown by arrow A. Gently pry
the indicated tab out of the small slot in the side of the
water bottle holder. Firmly push up on the bottom of the
water bottle holder until the tab remains outside of the
slot when the screwdriver is removed.
Next, insert the tip of the screwdriver between the
opposite side of the water bottle holder and the Console
(4) in the location shown by arrow B. Gently pry the side
of the water bottle holder away from the Console and
push the water bottle holder out of the Console.
Remove the right water bottle holder in the same way.
Next, locate the round audio cable jack. If there is a sil-
ver ring around the jack, remove the silver ring by turn-
ing it counterclockwise with the screwdriver.
2. Remove the four recessed screws (not shown) from the
underside of the Console (4). Do not remove the
screws attaching the Console to the Upright (3).
Hold the fan and the top of the Console (4) in the loca-
tions shown at the right. Carefully lift the fan and the
top of the Console; do not let the fan slide out of the
top of the Console.
3. While another person holds the top of the Console (4)
and the fan in a vertical position, slide the receiver onto
the indicated plastic pin on the Console; make sure
that the receiver is oriented exactly as shown.
Locate the two small screws included with the chest
pulse sensor. Attach the receiver to the Console with
the two screws as shown.
Connect the wire on the receiver to the indicated wire
on the Console (4). Note: The other wires included with
the chest pulse sensor may be discarded.
4. Refer to step 2 above. Lower the top of the Console (4) and the fan. Make sure that no wires are pinched.
Reattach the top of the Console with the four screws removed in step 2. Refer to step 1 above. Press the
water bottle holders back into the Console. If you removed a silver ring from the audio cable jack, reattach
the silver ring.
7
Pin
Wire
Screws
4
3
4
2
Receiver
3
Tab
A
B
Jack
Water
Bottle
Holder
1
4
Hold and lift here