Filter
Top Products
11
18. Route the Low Cable (72) through the indicated slot
in the Main Upright (3) and the Base (8).
Wrap the Low Cable (72) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley inside the weld-
ed bracket on the Main Upright (3) with a 3/8Ó x 2Ó
Bolt (62) and a 3/8Ó Nylon Locknut (50).
50
3
72
8
35
62
Slot
16. Locate the Low Cable (72), which is the only remain-
ing Cable. Note that it has a large ball on one end
and a small ball on the other.
Route the small ball on the Low Cable (72) through
the indicated slots in the Leg Lever (29) and the front
leg on the Base (8).
Attach a 4Ó Pulley (35) inside the slot in the front leg
of the Base (8) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó
Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings
(42), and a 3/8Ó Nylon Jamnut (63).
17. Attach a 4Ó Pulley (35) inside the slot in the Leg Lever
(29) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42),
and a 3/8Ó Nylon Jamnut (63).
Attach the Spacer (94) inside the bottom of the Leg
Lever (29) with a 5/16Ó x 2 1/2Ó Bolt (96), two 5/16Ó
Washers (80), and a 5/16Ó Nylon Jamnut (79). Refer
to the inset drawing. Press the Tab (93) onto the cage
as shown. Secure the Tab to the cage with a 1/4Ó x 1Ó
Bolt (98), a Fender Washer (97), and a 1/4Ó Nylon
Locknut (25). Make sure that the Low Cable (72) is
on top of the Spacer and the Tab.
Press a 2Ó Square Inner Cap (33) into the bottom of
the Leg Lever (29).
Note: It may be easier to attach the Spacer (94)
and the 2Ó Square Inner Cap (33) if you pivot the
Leg Lever (29) to a vertical position.
16
55
42
72
29
8
63
Slots
Large Ball
42
55
54
35
18
17
63
79
54
96
29
33
42
94
Cage
42
55
55
72
35
93
98
97
25
72
15
73
63
1
42
42
35
54
55
15. Feed the bolt on the end of the High Cable (73) up
through the wide slot in the Top Frame (1) as shown.
Wrap the High Cable around two 4Ó Pulleys (35).
Attach the Pulleys inside the slot in the Top Frame
with two 3/8Ó x 2 1/2Ó Bolts (54), four 3/8Ó Flat
Washers (55), four 5/8Ó x 1/2Ó Pulley Bushings (42),
and two 3/8Ó Nylon Jamnuts (63).
See the inset drawing. Thread the bolt on the High
Cable (73) two turns into the top of the Weight Tube
(36).
73
Bolt
36
80