Filter
Top Products
5
1. Press a 1 1/2Ó x 2 1/2Ó Outer Cap (5) onto each end
of the Right Base (7). Attach the Rear Base (8) to
the Right Base with two 3/8Ó x 3 1/2Ó Bolts (6) and
two 3/8Ó Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Attach two Lower Support Plates (13) to the Right
Base (7) with two 3/8Ó x 3 1/2Ó Bolts (6) and two
3/8Ó Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet. Note: Do not confuse the
Lower Support Plates with the Upper Support
Plates (not shown); when the Lower Support
Plates are attached to the Right Base, the edges
with three holes will slant backward slightly.
¥ Assembly requires two people.
¥ Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
¥ Two adjustable wrenches
¥ One rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Assembly
Make Things Easier
Everything in this manual is designed to ensure
that the weight rack can be assembled
successfully by anyone. However, the weight
rack has many parts, and the assembly
process will take time. Setting aside plenty of
time will make the process go more smoothly.
2. Press a 1 1/2Ó x 2 1/2Ó Outer Cap (5) onto each end
of the Left Base (2). Attach the Rear Base (8) to the
Left Base with two 3/8Ó x 3 1/2Ó Bolts (6) and two
3/8Ó Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Attach two Lower Support Plates (13) to the Left
Base (2) with two 3/8Ó x 3 1/2Ó Bolts (6) and two
3/8Ó Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
8
6
11
13
These edges
should slant
backward
slightly.
13
6
7
5
11
5
1
8
2
6
13
13
6
11
5
5
11
2